Blog

Opening and closing the hood is simple on the Jeep Patriot. Just remember, when opening the hood, two latches must be released.

First, pull the hood release level located on the left kick panel on the driver side of the vehicle.

Next, you will move the safety catch under the front edge of the hood, which you can find this near the center. Then raise the hood.

Clipped to the left side (when facing the hood) of the engine compartment is the hood prop rod. To secure the hood in the open position, lift the hood prop rod and place in the location stamped into the inner hood surface.

Note: to prevent potential damage, do not slam the hood to close it. Try to lower the hood until it is approximately raised approximately 8 inches, and then drop it. Both latches should be secured after doing this.

Also, you should never drive the vehicle unless the hood is completely closed and the latches completely secured.

If the hood is not completely latched, it is possible that the hood could open and block your vision when the vehicle is in motion.